Loader loading and unloading speed 5 skills

In the same way, some people can do it quickly and well, while others do it very slowly. Loading and unloading machines, for example, is sure to cause headaches in some machines. The following Xiaobian to teach you skills!

Technique 1

Drop the car to its best position

Before the loader loading, observe the best position of work area will be down to the dump truck, which can save time but also can improve the efficiency of.

Technique 2

Load plan

Before loading the loader, you should first think of the loading order, and try to keep it close to the front of the car, because when it is loaded quickly, it will not be said that the front is short of the shovel, and the loader should have a plan when loading.

Technique 3

When the material is full, push up the higher part

As soon as it's full, push the material over slowly and try to push the material to the lower side because the loader doesn't rise that high when it's actually loaded. If you still have one shovel, you'll have to install the back, because you're too full in front of one time, and it's very inconvenient to finish the top.

Technique 4

Grasp the time difference

The loader loading is mainly a time difference of the master, shovel, right to be diligent, big resistance when the car does not move, to manipulate the boom arm, don't drag a Big Slam acceleration, that is a waste of fuel and hurt the car, also can improve the work efficiency.

Technique 5

Be careful to do combined actions

Shovel: walk (forward), enlarged arm, flat bucket are done at the same time, go to the stockpile before, you should just put a bucket, can borrow a shovel into the momentum;

Tipping bucket, lifting arm and reverse at the same time, the car slowly pour arm, put the bucket down, was put forward, to continue walking and provided arms;

Unloading: go not far away from the vehicle began to skip unloading, don't worry about material poured out, because if the action fast enough, the material because of the effects of hysteresis inertia what would start to fall down, not immediately, when the bucket reaches the carriage in the edge, continue to skip at the same time at the same time, but also drop some big arms, to the right place, the bucket just turn in place, also stop down the arm, and then tap the brakes, the material will fall rapidly because of Inertia Momentum, don't pause for a second time.