The correct use of sand making machine, tested

As the main equipment of machine-made sand production, sand making machine is a hot equipment at present. Large equipment operation accident is not uncommon, safety operation is the vast number of sand making machine users are very concerned about the problem. How to operate the sand maker safely? Hongxing machine has sorted out the relevant rules and regulations for your reference.

1. first, you must start the device in the correct boot sequence. The correct starting sequence of the sand making machine and the conveying equipment is: discharging, impact crusher, feeder.

2. the crusher must start without load until the crusher runs normally. The stop sequence is opposite to the starting sequence.

3. during the operation of the crusher, there must be no violent vibration and abnormal noise, otherwise the parking should be checked.

4. feeding must be continuous and even, too much feeding easily cause accumulation blocking material, feed too little, the output is reduced, reduce production efficiency.

5. more than the provisions of the size of the feed is prohibited into the sand machine, otherwise it will cause the imbalance of the impeller and excessive wear of the impeller, and even cause clogging of the impeller channel and the center feed pipe, affecting the normal operation of the sand machine. Therefore, it is found that more than the required large pieces of materials should be promptly removed.

When the 6. row material equipment stops moving, it should stop feeding in time, otherwise it will cause the damage to the impeller and destroy the motor.

7., the operation should always check whether the equipment operation is normal, if abnormal, should stop immediately. If it is necessary to repair the machine, it should be done after shutdown. It is suggested that you ask the professional maintenance personnel to solve the problem. Without permission from the manufacturer, it is strictly forbidden to disassemble the core components without permission.

8. check the whirling chamber before opening the door to see whether the door is locked, so as to prevent the material from the vortex chamber observation door out of danger.

9. check the impeller rotation direction, from the feed port direction. The impeller should rotate counterclockwise, otherwise the motor wiring should be adjusted.

10. the end of production check whether there is broken material in the crushing chamber, to ensure that there is no material in the crushing chamber, to inspect the wearing of the wearing parts, and if the abnormality is found, it should be repaired immediately.

Learn more about sand machine knowledge, please pay attention to Red Star Machine official website, or customer service consulting.