The piping installation of the hydraulic system is stipulated         

Vast world, each has its own rules, for the fragile hydraulic system, of course, need to take care of all aspects. So, for hydraulic systems as well, the pipeline is complex, so remember the installation rules carefully.

Before installation, each hose must use clean dry compressed air to blow, and the pipe joint ends wrapped with plastic sheeting, withhold hose ends with a metal plug sealing.

1 should avoid sharp bends, the minimum bending radius should be 10 times the diameter of the above;

2 and the pipe joints should have a straight line transition part, its length should not be less than two times the diameter of the pipe;

3 the length is too long or sharp under vibration condition, should be used to hose clamp, but under high pressure hose should minimize the use of clip;

4 in the stationary and moving randomly, the pipe itself may not be torsion deformation;

5 level installed hose, when the weight will cause close to the joint part of excessive deformation, there must be a proper support or hose fittings part of the droop installation, into "U" shape;

During the intermittent 6 pipe installation, each nozzle should be tightly closed;

7 in addition to meet the bending radius and the length of travel, there should be about 4% of the allowance;

8 each other and with other objects may not be friction; from the heat insulation measures must be close;

9 piston hydraulic pump and hydraulic motor of the vent pipe should be directly back to the tank, and the pump / motor body and above the drain port is not allowed; several drainage pipe into the pipeline and it back to the same diameter of a tank, it does not allow the vent pipe is connected with the general oil return pipe, but hydrostatic transmission the dynamic system of the pump / motor and the hydraulic motor (such as speed) in the required pressure unless required.

10 double cylinder synchronous circuit of two hydraulic cylinders in the pipeline shall be symmetrically.

After the pipeline is connected, to confirm the seal, regular inspection and maintenance, if there is a problem, it will cause the whole machine failure, can not work, so should be particularly careful.