The working process of paver and main working system of paver

The working process of paver:

Before work, first check the machine status, confirm the paver system is good, oil, gas and water level normal. And then adjust the paver, and press out sections of the width and thickness, camber and other construction requirements, making it to be in a spreading state, start the engine, the machine will be running for 3-5 minutes, the whole system in the best working condition; command material transport truck alignment paver hopper car, to the paver 0.5-1 metres in front stop, push the car rear wheel slowly contact paver. Then open the transmission feeding switch, dumptruck car slowly rises, the mixture is slowly discharged into the paver hopper, the feeding belt is located in the hopper bottom and the mixture conveyed to the conveying groove in the rear of the host, and then by the spiral blade material distributing system of the mixture along the whole paver paving the width to the left and right horizontal conveying and the mixture evenly spread out to drown the 2/3 helical blade, open vibration and vibration, and then the paver started, mixture after the initial ramming screed, again vibration compaction, shaping and smoothing and the formation of a certain flat density and layer density.

Main working system of paver:

Power transmission system (hydraulic transmission, mechanical transmission)

Walking drive system (double drive, bridge drive, machinery)

Material delivery system (linkage system, independent system)

Electrical control system

Hydraulic system

Ironing device