Plentiful supply of small support wheels in Xugong RP902 paver

Everyone wants to find high quality Paver accessories, of which the weight wheel is a higher search rate, so what kind of support wheel is better?

Small support wheel of Xugong RP902 paver

Support wheel assembly standard:

1. Before assembly, each part is strictly checked and cleaned.

2. Before the axle sleeve and the straight shaft are assembled, a small amount of oil is applied to the matching surface.

3, the floating oil seal ring is paired and assembled, and the grease on its dense cover map;

4, the contact surface of the O type ring and the floating oil seal ring should not be coated with grease, and the O ring assembly must not be distorted.

5, the total installation force of floating oil seal ring is 450~500N, so as to ensure the axial clearance of the rear wheel body 0.4~0.9mm after assembly, and the wheel can be rotated by hand, with a certain resistance moment, but no sticking phenomenon.

6, in the assembly of the oil chamber without filling oil before use to plug office into 0.4MPa pressure seal, no air bubbles into the water 1min;

7. After the assembly is completed, it should be run in, and then the worn waste scrap is treated clean, and the quality of the cavities is more than 0.12g.

8, the floating seal ring can not have defects such as blowhole, scratch and so on.

The main function of the pulley is to support the weight of the excavator and the bulldozer, allowing the track to move along the wheels.

Mechanical engineering with fine steel according to the national standard of careful research, high strength, high hardness, perfect matching your device, and long service life, wear resistance, complete specifications, reliable quality and adequate supply by the vast number of users and Paver Construction units acceptance.

(this article is copyrighted to the home of the engineering machinery, if any reprint, please indicate otherwise.)