The mystery of safe transportation and loading and unloading of engineering machinery

Sometimes excavators need to be transported to destinations by trailers. In this process, there will also be various accidents. How can we avoid tragedies? Now come to talk about the safe transportation and handling of excavators.

Check carefully before, during and after the transportation, to see if the match, the transportation capacity, and the safety of the traffic.

Be sure to check the size of the machine carefully. According to the installed working device, the weight of the machine, the height of the transportation, and the total length will be different.

All bridges and other structural parts that preinspect the route of transport have sufficient strength to bear the total weight of the trailer and the machine shipped.

The machine can be divided into several parts for transportation, so when transporting the machine, please contact the dealer for this work.

In the loading and unloading process, we should pay attention to the surrounding environment to ensure smooth and smooth loading and unloading of the excavator.

When the machine is installed or unloaded, the wrong operation will bring the danger of turning or falling, so special attention should be paid. Be sure to do the following.

Only loading and unloading cars on a solid, flat ground. Keep a safe distance from the edge of a road or cliff.

Do not use the work device to install or unload the machine. In this way, there will be a danger of falling or tilting.

Be sure to use a springboard with enough strength. Ensure that the width, length and thickness of the springboard are sufficient to provide a safe loading and slope relief. Measures should be taken to prevent the springboard from shifting or falling off.

Ensure that the surface of the springboard is clean, without grease, oil, ice and loose material. Remove the dirt on the machine's crawler. Especially on rainy days, because of the springboard

The surface is wet and slippery, and should be particularly careful.

The automatic deceleration switch must be closed to the machine equipped with automatic deceleration device. If we operate the machine under the condition of the automatic deceleration system open, there will be a sudden acceleration of the engine speed, the danger of the sudden movement of the machine or the faster walking speed of the machine.

Operate the engine at a low idle speed and operate the machine at low speed.

Do not operate any joystick except the walking joystick when the springboard is on the board. Do not fix the direction on the springboard. If you need it, drive the machine away from the springboard, correct the direction, and then drive up the springboard.

In the connection between the springboard and the trailer, the machine's center of gravity will suddenly change, and the machine is in danger of losing its balance. When you cross this part, walk slowly.

When loading and unloading the machine on a embankment or platform, it is necessary to ensure that it has a suitable width, strength and gradient.

The trailer is unstable when the upper revolving platform is turned on the trailer, so it is necessary to take back the working device and turn it slowly.

For a machine equipped with a cab, lock the door after loading the car. Otherwise, in the course of transportation, the door will suddenly open.

In a word, the transportation and loading and unloading process should be carefully, carefully and carefully, and the important words are three times.