Counterattack crusher for equipment maintenance

Counterattack crusher is not unfamiliar to construction machinery users, it is a common crushing equipment in the sand production line and crushing production line, which is famous for its product grain type. A good equipment is not only good configuration, good material can be used for a long time, the key depends on the user's love and maintenance.

How to maintain it, Xiaobian made a summary to you, I hope you can use it.

First of all, after the new machine has been put into operation, every round of work must be completed to check the counterattack thoroughly. After a week of running, the counterattack broken motor, lubrication for a comprehensive inspection. The inspection includes the fastening of fixed parts, belt drive, bearing seal, counterattack lining plate, liner wear situation for full release inspection, and combined with the maintenance cycle to establish regular maintenance and replacement system.

Counterattack crusher for equipment maintenance

Clearance adjustment between rotor and counter liner: when the rotor of the counter crusher is running, the clearance between the rotor and the counter liner can not be adjusted. If the material block is stuck between the back plate and the plate and shell, it is suggested to lift the counterattack frame slightly between the re adjustment gaps, so that the block feeding will become loose and the counterattack frame is easy to adjust.

If the back frame is not adequate, can pat in a relaxed rod (with a piece of wood, the rotor and the gap protection) impact plate is accomplished by adjusting device of the machine, first loosen the bolts, and then rotate in the long nut, then pull upward direction, adjusting screw sets that will tighten.

Replace vulnerable parts: counterattack crusher replacement of vulnerable parts, first open after the shelves. When the utility model is used, the connecting bolt of the upper frame and the middle box body is firstly unloaded, and then the wrench is screwed to the six corner head part of the flip device, and then the frame is opened slowly. At the same time, the rear frame can be hung by the hanging device above the rack. Repeat the above process, that is, up and down shelves.

Bearing: too high temperature may be due to excessive or insufficient grease, grease dirt, bearing damage, replacement bearing back crusher in the sand production line plays a key step.

Liner: after opening the cover, remove cotter pin, for fixing impact plate slotted nuts, bolts, it will wear the impact plate after replacement. If install new counterattack lining board, reverse these steps immediately.

Plate hammer: counterattack plate hammer wear to a certain extent, should be adjusted or replaced in time, in order to avoid damage to fasteners and other components.

Do every detail, hope the user in the counterattack crusher use process, fully repair and maintenance, the problem nipped in the bud, in order to ensure the counterattack crusher long-term normal and smooth operation.