A paver gear toggle switch drops

Switches are very common in our lives, and its invention allows us to make better use of equipment to do things. There are also switches in the paver, but how much do you know about the paver's switch? The Xugong RP75 paver, is known as a toggle switch gear parts, below I introduce the related knowledge of the toggle switch.

Toggle switch is a manual control switch, mainly used for AC and DC power on-off control circuit, but also can be used in the circuit or a few kHz up to 1 MHz. It has the characteristics of small size, easy operation and so on. It is a common switch in electronic equipment.

A paver gear toggle switch drops

Using the principle of the toggle switch

In manual operation, the switch can be divided into two stages. The first stage is to pull the handle to the middle by hand until the handle is perpendicular to the handle. At this point the tip of the single knife slider is gradually closer to the middle, until the middle position, and the pressure spring is further compressed. After the handle is over the vertical position, the single slide block moves rapidly in another direction under the action of the pressure of the spring, and drives the handle to turn quickly. Then the moving contact piece is rapidly separated from the fixed contact foot on one side and rapidly connected with the fixed foot on the other side, this is the second stage. At this time the separation speed of the contact is related to the size of the pressure spring and the friction between the moving parts, and the speed is very high. According to the test, the time from the departure of the contact to the reconnect is only about milliseconds, and the average speed is up to the old millimeter. This speed is many times faster than the manual wrench or the maneuver test.

Note the toggle switch

(1). First of all, the appropriate type of switch and connector should be selected according to the use conditions and functions.

(2). The switch, the rated voltage of the connector, the current should have a certain allowance

(3). In order to contact reliability, the contacts of the switch and the number of lines of the connector must have a certain allowance for parallel use or standby.

(4). Choose the connector with positioning as far as possible, so as not to insert the wrong and cause trouble.

(5). The connection and welding of the contact are reliable. In order to prevent the broken line and short circuit, the welding place should be protected by the casing.

The switch often causes the switch to fail. At this time, you need a new and good use of the accessories.

XCMG RP75 paver toggle switch gear

A friend who needs it will come to the home of the engineering machinery.

(this article is copyrighted to the home of the engineering machinery, if any reprint, please indicate otherwise.)