Operation steps of low temperature preheating starting device of RP952 asphalt paver

1) RP952 asphalt paver starting before inserting the key and the key from 0 to 1, click the start button to unlock the switch S8, and then I transferred to a second position from preheating, preheating, if the engine temperature is higher than 0 DEG C or too battery power loss (voltage below 19V), preheat indicator H2 2 seconds after the light is extinguished, the preheating device stops working. If the engine water temperature is lower than 0 degrees or the battery is in good condition, the preheating device starts to work. The preheating plug starts to preheat, and the preheat indicator H2A lights up to indicate preheating.

2) preheat about 30 seconds, preheat end, preheat indicator H2 extinguished, indicating that the driver can Qidong diesel engine. The key starts from the preheating position II to the starting position III to start the key.

3) if the preheating indicator H2 is extinguished after 30 seconds without starting operation, the preheating controller will automatically stop working. If the preheat indicator H2 extinguished within 30 seconds after the driver press the start button to start operation, re preheating indicator light, diesel preheating electromagnetic valve into the hot glow plug and ignited a flame, diesel engine intake preheating pipe of the diesel engine is easy to start.

4) if the start-up is successful, the preheating device will automatically enter the post heating stage, so as to achieve the purpose of warming the car, and the heating time is 60 seconds, at this time, the diesel engine should remain idle state.

5) if you want to re-enter the warm-up start, you must stay for 5 seconds to repeat the above action process.